Nice looking stuff there Craig.
Specific gravity can be measured by taking a small or large piece of your lumber. A cut off is probably best and make sure it is equal in dimensions along the length. I need not be square, but if wedge shaped, it should be the same all the way from end to end. For example cut off a 4 inch end piece about 1 inch wide. 1x1x4 for example. Dip it it water and it will make a water mark, now dip the other end and mark that line. Take the average of the two measurements and divide by total length to get Specific Gravity.
If you saved any cut offs from your last bass, measure them also and compare the butternut.
Let us know.
|