[Ruben E garcia]

No no nooooo!!!.... I am good in that department, It doesn,t really show in the picture but that chisel its very sharp, I did spend yesterday more than an hour sharpening that chisel its deadly sharp


I start by flatting with 80 grip sand paper on a granite stone, then I move to 320g sand paper, and so on…
Then I use my Veritas honing jig and register jig (Amazing little tool) for the bevel a 25 degrees again 80G, 320G, and tree diamond stones 320, 600, 1000. After that I use and 2000G sand paper and finally a leather belt for mirror finish…. When I done I do a 30 Degrees micro bevel… and I use the back on my The thumb nail to make sure its sharp…

Also while I am working I am make sure stay sharp… by honing it with my leather belt… those chisels my be not the best chisels out there but they hold the bevel sharp as long I don’t mess with too much H. glue or little metal wires like the ones that I found on some of the patches in my DB

PS it doesn’t give me you a lot of room for accidents