Quote:
Originally Posted by Bob Branstetter
Thanks for the offer on A0-B0 Ken, but I got my fill of discussing it over on the TalkBass Forum. It was unfortunate that none of the luthiers over there were unwilling to seriously look into it and try it for themselves, preferring to declare it bogus and putting me in an adversary role defending the concept. I can only say that I have used the process successfully on many basses and believe that it is tool that should be in every luthier's shop. After going through that rather unpleasant experience on TalkBass, I made a personal decision that I will not discuss it any longer on any forum or Internet discussion group. However, I am always available to answer legitimate questions from anyone who is truly interested in trying A0-B0 matching by email or PM. I have sent out many copies of my 1996 Michigan Violin Makers Assn Paper on A0-B0 matching in basses to interested individuals as email attachments. The same offer also applies to questions about the Vibration DeDamping process which we briefly touched on in an earlier thread on this forum.
|
Ok, on that note, I would like to have one of each for my reading and files. I am sure there is something to gain there if one makes the effort. I on the other hand have been fortunate enough to choose Basses that need very little help other then the obvious repairs needed. Maybe I have done some matching on my own but didn't know I was doing it. I have set-up and improved quite a few basses in my time going by just feel. It would be good to see this in print. Maybe some others here would try this and discuss their results and that way we could have an A/B forum that you might, just might visit on occasion and give a shout once in a while.. That would be nice.