Quote:
Originally Posted by Adrian Levi
Here are a couple of pics. The centre join had a piece of epoxied wood in it up to the big brace as can be seen in the pics. The back sits perfectly on the ribs now after I took it off (before it was being pulled in all directions from the epoxy).
Now what route to take.... full center seam inlay ???
Due to massive peer pressure I will replace the back brace .
Any advice on how many braces the bass will need , Im guessing 3 or will sturdy patches along the centre seam be an option ...?
|
Adrian, you have a tricky repair ahead of you. If the back is wide enough to fit on the rib assembly with some margin (overhang), then you'll just need to fill the big gap in the lower part of the back. If the back needs widening, you may want to add a strip down the center. Either is a difficult job. If you are going to fill the existing gap, start by gluing several temporary braces across the gap, using them to hold it together and flatten the area while you fit a patch. These braces should be about 6" or so long, attached with reversible glue.