All fixed and ready to play. When something like this happens, you never know if all is back 100% where it was exactly.
It feels good and sounds good but I had to chisel down the ends of the two dowels I glued in to the old wire slots and get it flush with the Rosewood with not much room to work in those curved channels. Some sanding and touch-up and it looks just fine.
Then drilling new holes thru the top of the Tailpiece on a beveled surface, angling the holes slightly from outside to inside to spread the wire and getting the wire clamp back on and to a similar length was nothing short or tedious work. I must be getting soft, too much bowing and not enough chiseling because my fingers and hands are sore!
But, shes ready for service now without changing anything else and that's a relief.