[Ruben E garcia]

Originally Posted by Arnold Schnitzer

Yes, just glue it and clamp it. Don't worry about applying too much clamp pressure. Fine Woodworking had a great article a few years ago where they tested joints put together with varying amounts of clamp pressure, and different glues. What they discovered to everyone's surprise, is that there is no such thing as a "starved" glue joint. The high-pressure joints, though they squeezed out more of the glue, were actually stronger.

Yes I always though that too much pressure will squeeze the glue out….

Originally Posted by Arnold Schnitzer

When you get ready to glue in your soundpost patch, make sure you size the wood of the bass top and the patch with thin hide glue, because there will be considerable end grain revealed. Without sizing, the glue will soak into the endgrain too much and the joint will eventually come apart. Also, if you are not using a counter form on the opposite side, you will need a lot of clamps, and you'll need to apply them quickly. Gluing down temporary cleats around the soundpost patch will keep it from sliding around when it's full of slippery glue

1. So I should apply thin coat of glue in both sides top and SP patch…
2. The counter form you mean by the front of the Bass top right?
3. Temp Cleats around the SP patch like the Mathew’s Restoration…