Hello

[Craig Regan]

1) This is not a luthiers tool, but it got me through the job!
The cutters worked well, but the fence had to be modified so it could follow the curves of a bass.

2) Shop made purflings using different thickness veneers. They were glued up in forms that matched the contours of the bass

3) The preformed purflings waiting to be installed.

4) First purfle!
Cherry wood was used in the center to match the ribs and back. I did some preliminary edge shaping with small files; this is an attempt at a "sculpted edge". I hope it doesn't look too thick or get in the way of the bow.

5) The purfling is a bit on the heavy side compared to other basses, but I think it will blend just fine. Sometimes bold can be good.