#1
|
|||
|
|||
Getting ready to restore
I'm getting ready to restore this bass. I would like an opinion about this instrument before I decide how much to do. I can't tell who made it. The only label is the "Made in Chechoslovakia" sticker. Can anyone tell the approximate age? I have owned it since 1958 or so. Played many jazz gigs over the years.
|
#2
|
||||
|
||||
"Made in Chechoslovakia" sticker..
Quote:
|
#3
|
|||
|
|||
Ken,
Do you think that it is worth replacing the finger board, tail piece and saddle with ebony? Really, what I spend on the bass depends on a value after repairs. Can you estimate a value range? Thanks |
#4
|
||||
|
||||
humm?
Quote:
On the Bass itself, it has extensive damage to the Back and the Top, both of which look to have been poorly repaired in the past. This will be an expensive restoration to set right. The Ebony parts is not your main expense but rather minor in comparison. To cost to restore this bass might exceed its total value in your area as well as mine. If it were a German roundback of a similar vintage I would say it would hold slightly more value as the Round Back is rarely an issue. Your best bet might be to clean it up as inexpensively as possible and put a new Fingerboard and Nut on. The TP is not important unless it's broken. I had a rosewood type TP on my 18th century Italian bass for 20 years and never thought twice about changing it. For the Varnish, knock down that gloss and unevenness about it and put some darker coats over it. Don't bother stripping it. It's not worth it and not so easy either. These kinds of basses sometimes sound better than they look and sound more expensive that they are worth. Get it ready for use and enjoy it. |
#5
|
|||
|
|||
Thank you Ken. That is about what I expected. It does sound good and I have had a lot of fun with it over the years. I appreciate your time. I have also enjoyed reading several of the threads. It is very educational.
Thanks |
#6
|
|||
|
|||
Improve existing finish
Ken, How can the existing finish be smoothed out? The finish is an oil based spar varnish.
Thanks |
#7
|
||||
|
||||
??
Spar varnish? On a musical instrument? Yikes.. Don't know.. Not my expertise. I thought Spar varnish was for boat decks and railings..
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|