...not much for photos but there are some updates starting here
http://www.upnorthstrings.com/cornerlessbasspage4.html
I did two things:
1. Narrowed the waste just a bit by removing the linings and bending the side in just a half inch above the narrowest part of the middle bout.
2. Planed the ribs for less depth by tapering them from tail block to neck. This will leave the ribs about 9 1/2 at the end block but narrowing to 8/12 at the area where the back bends in, then tapering in to 6 1/2 for better reach-around.
Oh yea and I jointed, joined and started planing the top. Nice old seasoned spruce wood.
03-03-2007, 01:22 AM
Threaded Mode