Guitar and Pear-Shaped

[Ken McKay]

I will try to stay less than 42 inches mensure.

Arnold, if I use +1 inch fudge factor, I get very close, thanks.

Matthew, Keep in mind that the long arch from top to bottom is almost perfect from the planer and since my wood started as pie shaped wedges, there is less roughing to be done compared to your 2 inch thick cedar. I get no tear out if I carve up, bottom to top, on the bass side and down on the treble, it is just the way this spruce wants to be carved, so I go with the grain to stay perfectly in control, and every gouge stroke leaves a shiny surface behind.

I will establish the flat perimeter next at a perfect thickness + 1/2 mm. Then my next tool is going to be a plane, to round the flat area into the generously arched barrel shape. Then a series of sharp gouges that match the recurve will be used to blend the two, then scraper.

As always, thanks for the comments and help.