The 5-String Double Bass

[David Powell]

I had matched the radius of the fingerboard at 72mm, I think or somewhere close to that. I haven't measured the radius of the bridge. I based it on the original bridge which was fine height wise, the spacing was just too close for arco. Ideally, I think a slightly tighter radius would be better on the fingerboard. But before I do that, I could reset the strings just a little wider. G, D, and A are all fine, E is a little tight. Or I could go for one inch between instead of 1 inch on center. I'll try that first with a different spacing on the original bridge. It was a lot lighter maple, but it still sounded good. If I put adjusters in it, I could trim the top and try the different spacing.

Thanks for the compliment on the bridge. The photos are close enough to show the small mistakes. I totally abstained from any sandpaper on that one. I just wanted to see if I could do it. I used two flexcut knives and a little modeling plane. The planer really brought out the rays in the maple. Scraping it to clean it was a tip I got from you somewhere along the way.