Endpin talk...

[Mike Mandelas]

I have tried all alternatives in my three basses. In wooden floors the KC endpin (carbon rod with wooden pin) works better in all of them. The CF rod i bought from Upton makes also an improvement in wooden floors but in concrete (tiles, marble etc) the effect is not so strong. "Better" means louder, warmer and IMHO more fundamentals.

However, following some of master Arnold's observations, i managed to optimise the sound of two "dark" basses with metal rods in ebony endpins housings (cut in the needed length). In those basses the wooden pins didn't make any difference. Now i'm working in a German hybrid which has a"choked"
sound. The CF by Upton seems to be the best solution so far but i have to record the change each time in order to arrive in proper conclusions.

[Ken Smith]

I don't know where Arnold and Jeff gets theirs (the same one) but it's about the best I have seen anywhere. Arnold? Does it have a name?

Anyway, my current main Bass is kinda huge so I have it all the way in or an inch out at most for the spike for sitting. I did one orchestra concert standing and it was difficult to find a height I liked for both the left or right hand combined. Sitting seems to make the difference. Most or my endpin in in the bass, not sticking out. I have cut one of them already and may cut this one as well. If I lean the bass back further I can raise the 'pin up a bit but then the angle of my bow arm is increased and I don't like that at all. The straighter the better for me.

[Calvin Marks]

Originally Posted by Mike Mandelas

I have tried all alternatives in my three basses. In wooden floors the KC endpin (carbon rod with wooden pin) works better in all of them. The CF rod i bought from Upton makes also an improvement in wooden floors but in concrete (tiles, marble etc) the effect is not so strong. "Better" means louder, warmer and IMHO more fundamentals.

However, following some of master Arnold's observations, i managed to optimise the sound of two "dark" basses with metal rods in ebony endpins housings (cut in the needed length). In those basses the wooden pins didn't make any difference. Now i'm working in a German hybrid which has a"choked"
sound. The CF by Upton seems to be the best solution so far but i have to record the change each time in order to arrive in proper conclusions.

This is what I use:

http://www.n-pin.com

Finest end-pin in the market, the carbon fibre rod weighs around 30 grams.

[Joel Larsson]

Originally Posted by N-Pin

Cello N-PIN: $219.87 for full unit
Bass N-PIN: $208.44 for full unit

At last something that's cheaper for bass! I like this company.

[Calvin Marks]

Originally Posted by Joel Larsson

At last something that's cheaper for bass! I like this company.

The maker was a professional bassist and a trained machinist.

You don't have to worry about stripping the screw since it has a bike-clamp mechanism. Also the carbide tip never wears down and it works on almost every surface, very stable!