|
#1
|
||||
|
||||
By-pass?
Quote:
1. Why would you want to bi-pass the Eden pre-amp? 2. What do you mean by "turning up the Eden pre past 9 o'clock"? I suspect you mean the Gain and/or Master being turned up past 9? You're not going to hurt the 550 unless you take the load below 2 Ohms. 3. Can I assume you want to use the U5 as THE pre-amp and the 550 as the power source? If yes, the answer would be to run 'Out' of the U5 into the 'Effects Return' of the 550, thus, by-passing the 550's pre. Tim B.
__________________
Tim Bishop Last edited by Tim Bishop; 10-10-2007 at 06:47 PM. |
#2
|
|||
|
|||
Bypass
Quote:
|
#3
|
||||
|
||||
Why?
Quote:
__________________
Tim Bishop |
#4
|
|||
|
|||
Avalon
Whenever i plug into the gain stage of the Eden coming from the Avalon,i get an incredible low frequency hum if i try to pass 9 o'clock with the Gain.I tried what you said last night(#3) and also got almost the same results,though not as severe as going through the gain stage.Clueless at this point
|
#5
|
||||
|
||||
???
Quote:
Quote:
Are you sure there are no issues with the U5, Eden or cable you are using? Also, double-check your 'Ground Lift' on the 550. Also, I'm still a bit puzzled. Why would you not just want to use the 550 with it's pre-amp and other great features? Another option if you want to use the U5 as your pre: Try going from your U5 'Out' to the 550 'Aux' In.
__________________
Tim Bishop Last edited by Tim Bishop; 10-11-2007 at 08:32 PM. |
#6
|
|||
|
|||
Avalon
Quote:
|
#7
|
||||
|
||||
Still trying....
Quote:
Did you try going out of the U5 into the 550 Aux In?
__________________
Tim Bishop |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|